Aqara Philippines

Water Leak Sensor T1

Menu

FAQs

Possible reasons:

  1. The accessory is too far away from the Hub, please try to install the accessory closer to the Hub.
  2. Low battery or dead battery. Please replace the battery.
  3. The accessory is installed on the metal surface and the signal is interfered. Please avoid metal surface.

Possible reasons:

  1. Operation error. Please add the accessory according to Add Accessory method again.
  2. The accessory is too far away from the Hub. Please move the accessory closer to the Hub.
  3. There are more than 32 accessories under this Hub.
The Water Leak Sensor T1 detects water leak and flooding and monitors the status of water leak. When the water leak or flooding occurs, it sends an instant alert notification via the app. It also works with other smart accessories to automate your home.
Water Leak Sensor T1 makes use of the electrical conductivity of water. When two probes come into contact with water, a current loop is formed. At the same time, the sensor reports water leak/flooding status to the Hub and thereby triggers the alarm or turns on other smart accessories connected with it to execute relevant actions.

Water Leak Sensor T1 communicates with the Hub through Zigbee protocol wirelessly. Zigbee technology is a short-distance and low-power consumption wireless communication technology. As a communication protocol for smart home control system, it has become popular in recent years. Compared to other communication protocols, it has the following advantages:

  1. Ultra-low power consumption;
  2. Safer;
  3. Ad hoc network, accommodating more accessories.
No, it can't. The Water Leak Sensor T1 must work with a Hub.
The installation of Water Leak Sensor T1 is simple and easy. You just need to place it on a surface that needs to be monitored.
The installation of Water Leak Sensor T1 is simple and easy. You just need to place it on a surface that needs to be monitored.
Alarm can be triggered when the water level reaches up to 0.5 mm （0.02 inch).
The button of the Water Leak Sensor T1 is located at the center of the shell. Trigger the button by holding the top and bottom cover and pressing the "Water Drop" icon.
The Zigbee antenna of the Water Leak Sensor T1 is onboard antenna. It is right under the "Water Drop" icon.
The Water Leak Sensor T1 uses one CR2032 lithium battery. The output voltage of the battery is 3V. Normally, the service life of the battery is about two years (The actual service life depends on specific circumstances).
The Zigbee antenna of the Water Leak Sensor T1 is onboard antenna. It is right under the "Water Drop" icon.

Discover more from Aqara Philippines

Subscribe now to keep reading and get access to the full archive.

Continue reading