Skip to main content

Aqara Philippines

Touchscreen Dial V1 EU

Menu

FAQs

  1. Use a flat-head screwdriver to pry open the switch panel.
  2. Use a screwdriver to loosen the terminal screws on the back of the switch, connect the live wire to the L hole, connect the neutral wire to the N hole (refer to actual with/no-neutral wiring in your house), connect the load (light) wire to the L1, L2, confirm the wiring is correct, then tighten the terminal screws. Note: The maximum load must not exceed 2200W.
  3. Use the supplied screws to secure the switch to the wall junction box and snap on the switch panel. Note: Please ensure the main power is turned off before installation!
When first-time powered on (not connected to the network), it will enter networking mode by default (screen displaying an adding QR code). Reset after connection: go to “Settings” - “Rebind” in the device's drop-down menu.
  1. If the wiring is incorrect, the wall switch may fail to operate or even short-circuit, potentially causing damage. Be sure to follow the wiring instructions carefully or consult a professional electrician for installation.
  2. If the neutral and live lines are reversed, the switch may still work, but turning it off leaves the live line active at the fixture, creating a shock hazard. If the light load (L1) is misconnected to the L or N terminal, there won’t be a short circuit, but the switch won’t respond until correctly connected.
How much power is required for the lamp to work properly with the Touchscreen Dial V1? No minimum load requirement, but the maximum current under resistive load conditions for the total number of circuits is 8A, Max 8 A (Resistive Load).
Supported device: lights, curtain controllers, thermostats, switches, sockets, etc. Meanwhile, associated devices continuously updated and improved. Specific products may vary based on actual usage.
The device is a Wi-Fi device and can operate independently without a hub. Note: to configure Aqara Zigbee devices, a compatible hub is required.
Maximum number: 18.
This product does not have a built-in voice assistant, but you can enable Aqara Copilot for its control.
This product supports HomeKit. Once successfully connected to HomeKit, the product will display as 2 electrical switches (wired to load) and 6 wireless switches.
  1. In the Aqara Home app device details page, select “Configure”.
  2. Tap the bottom “Add” button to configure the necessary devices, scenes, etc.
Touchscreen Dial V1 supports 2 loads (L1, L2).